System Error Codes
2-10 HP Designjet T Series — Service Manual
System Error: 06:YZ
Problem
Description:
Failure reading/writing NVM in Hard disk.
Corrective Action: Try the following:
1 Switch the Power OFF from the back of the Printer and disconnect the Power
cor
d. Reconnect the power cord and power On the Printer.
2 If the System Error continues, replace the Formatter. See
Formatter on page
6-200.
System Error:
08:YZ (T1100/T1100ps/T610 ONLY)
Problem
Description:
No comunication between the Front Panel and the Main PCA.
Corrective Action: Try the following:
1 Switch the Power OFF from the back of the Printer and disconnect the Power
cor
d. Reconnect the power cord and power On the Printer.
2 Check that the Front Panel interface cable is
not damaged and is correctly
connected between the Main PCA and the Front Panel.
3 Check that the connections between the Formatter and the Main PCA are
not d
amaged and are correctly connected.
4 If the System Error continues, replace the Formatter. See
Formatter on page
6-200.
5 If the System Error continues, replace the Main PCA. See
Starwheel
Assembly on page 6-208.
6 If the System Error continues, replace the Front Panel. See
Front Panel on
page 6-47.
System Error:
08:YZ (T1120/T1120ps ONLY)
Corrective Action: The LEDs of the formatter (visible through the cover) and the power supply
can help you troubleshoot a problem when the Front Panel is blank.
The following image shows the Power Supply LED, looking through the cover.
To Next Page
Loading...