System Error Codes
2-18 HP Designjet T Series — Service Manual
System Error: 45:YZ
Problem
Description:
An error with the Rewinder System has been detected.
Corrective Action: Try the following:
1 S
witch the Power OFF from the back of the Printer and disconnect the Power
cord. Reconnect the power cord and power On the Printer.
2 C
heck that the Rewinder cable is not damaged and is correctly connected to
the PrintMech PCA.
3 Chec
k that the Right Spindle Holder (rewinder included) is correctly attached
to and aligned with the Right Cover.
4 P
erform the Rewinder diagnostic test to troubleshoot the problem further. See
6. Rewinder on page 3-34.
5 R
eplace the Right Spindle Holder (rewinder included). See Right Spindle
Holder and Rewinder (T1120/T1120ps) on page 6-87 or Right Spindle
Holder and Rewinder (T1120/T1120ps) on page 6-87.
6 If
the System Error continues, replace the PrintMech PCA. See PrintMech
PCA (T1100, T1100ps, T610 ONLY) on page 6-73.
System Error:
47:03
Problem
Description:
Star wheels motor error.
Corrective Action: Try the following:
Same as 47:YZ. The error is continuable, but only if it happens from time
to time.
System Error:
47:YZ
Problem
Description:
Star wheels motor error.
Corrective Action: Try the following:
1 S
witch the Power OFF from the back of the Printer and disconnect the Power
cord. Reconnect the power cord and power On the Printer.
2 C
heck that the Starwheel Assembly cable is not damaged and is correctly
connected to Main PCA.
3 Op
en the Window and check for any visible obstacles restricting the
movement of the Starwheel Assembly, then clear the obstruction.
4 P
erform the Scan Axis Starwheel diagnostic test to troubleshoot the problem
further. See
Star Wheel Lifter test on page 3-7.
5 R
eplace the Starwheel Motor. See Starwheel Motor on page 6-245.
6 If
the System Error continues, replace the Main PCA. See Starwheel
Assembly on page 6-208.
To Next Page
Loading...