HP Designjet T1120

Safety precautions
The following precautions ensure the proper use of the printer and prevent the printer from being
damaged. Follow these precautions at all times.
●
Use the power supply voltage specified on the nameplate. Avoid overloading the printer's electrical
outlet with multiple devices.
●
Ensure the printer is well-grounded. Failure to ground the printer may result in electrical shock, fire
and susceptibility to electromagnetic interference.
●
Do not disassemble or repair the printer yourself. Contact your local HP Service Representative
for service, see
Contact HP Support on page 186.
●
Use only the electrical cord supplied by HP with the printer. Do not damage, cut or repair the power
cord. A damaged power cord has risk of fire and electric shock. Replace a damaged power cord
with an HP-approved power cord.
●
Do not allow metal or liquids (except those used in HP Cleaning Kits) to touch the internal parts of
the printer. Doing so may cause fire, electric shock or other serious hazards.
●
Power OFF the printer and unplug the power cable from the power outlet in any of the following
cases:
◦
When placing your hands inside the printer
◦
If there is smoke or an unusual smell coming from the printer
◦
If the printer is making an unusual noise not heard during normal operation
◦
A piece of metal or a liquid (not part of cleaning and maintenance routines) touches internal
parts of the printer
◦
During an electrical (thunder/lightning) storm
◦
During a power failure.
HP Start-Up Kit
The HP Start-Up Kit is the DVD that comes with your printer; it contains the printer's software and
documentation, including introductory multimedia tutorials to help you to get a good first print.
Using this guide
Using your printer (on DVD) and the Quick Reference Guide (on paper) are organized into the following
chapters. The most complete source of information is Using your printer.
Introduction
This chapter provides a brief introduction to the printer and its documentation for new users.
Use and maintenance
These chapters help you carry out normal printer procedures and include the following topics.
●
Installing the software on page 11
●
Setting up the printer on page 21
●
Personalizing the printer on page 27
2 Chapter 1 Introduction ENWW
Introduction