3. Insert the new printhead into its correct slot in the carriage.
CAUTION: Insert the printhead slowly and vertically, straight down. It may be damaged if you
insert it too fast, or at an angle, or if you rotate it as you insert it.
4. Push down as indicated by the arrow shown below.
CAUTION: When installing the new printhead there may be some resistance, so you need to
press it down firmly but smoothly. You should hear a beep and see confirmation on the front-panel
display that the printhead has been inserted. If you have difficulty, see
Cannot insert a printhead
on page 168.
5. Insert all other printheads that need to be installed, and close the carriage lid.
122 Chapter 11 Handling ink cartridges and printheads ENWW
Ink and printheads
To Next Page
Loading...