HP Designjet T1120

To Next Page

To Previous Page

The paper is cut when the print has been completed

By default the printer cuts the paper after the drying time has been completed, see Change the drying

time on page 52. You can disable the cutter, see Turn the automatic cutter on and off on page 53.

The cutter does not cut well

By default the printer is set to automatically cut the paper after the drying time has been completed.

If the cutter is turned on but not cutting correctly, check that the cutter rail is clean and clear of any

obstacles.

If the cutter is turned off, the Form feed and cut key

only advances the paper. Use this key to move

the print far enough out of the front of the printer, until it is convenient to manually cut with a straight

edge or scissors.

The roll is loose on the spindle

The roll may need to be replaced or reloaded. If your roll has a three-inch cardboard core, ensure the

core adaptors supplied with the printer have been installed, see

A strip stays on the output tray and generates jams

If a small piece of paper (200 mm or smaller) has been cut, such as before (if new roll) and after a full-

bleed print or after the Form feed and cut key

has been pressed, the cut strip remains in the output

tray. Only when the printer is not working, reach in the tray and remove the strip.

Recalibrate the paper advance

Accurate paper advance is important to image quality because it is part of controlling the proper

placement of dots on the paper. If the paper is not advanced the proper distance between printhead

passes, light or dark bands appear in the print and image grain may increase.

The printer is calibrated to advance correctly with all the papers appearing in the front panel. When you

select the type of loaded paper, the printer adjusts the rate at which to advance the paper while printing.

However, if you are not satisfied with the default calibration of your paper, you may need to recalibrate

HP Designjet T1120 - Page 158