Change the front-panel display contrast
To change the contrast of the front-panel display, select the Setup menu icon , then Front panel
options > Select display contrast, and enter a value using the Up or Down key. Press the OK key to
set the value. The default contrast is set to 50.
Change the units of measurement
To change the units of measurement in the front-panel display, select the Setup menu icon ,
then Front panel options > Select units, and select English or Metric. By default the units are set to
metric.
Configure network settings
To configure the same network settings from the front panel, press the Menu key to go to the main menu
and select the Connectivity menu icon
. You can view and configure the following network settings.
●
USB: view information about the USB connection
●
JetDirect EIO: view information, configure and reset the JetDirect connection
●
Advanced > Select I/O timeout: specify the number of seconds that an idle connection is allowed
to remain open, 270 is the default value, if set to zero, the timeout is disabled
●
Advanced > Allow SNMP: specify whether SNMP is permitted
●
Advanced > Embedded Web Server > Allow EWS: specify whether the Embedded Web Server
is enabled
●
Advanced > Web Services > Printer Utility software: view the Printer Utility software settings
●
Advanced > Web Services > Color and paper management: view the color and paper
management settings
Change the graphic language setting
NOTE: You should not need to change the default graphic language setting (Automatic), and you are
not recommended to do so.
You can change the graphic language setting from the front panel. Press the Menu key to return to the
main menu the select the Setup menu icon
, then Printing preferences > Select graphic
language. Select one of the following options and press the OK key to set the value.
●
Select Automatic to let the printer determine which type of file it is receiving. This setting works
for most software applications.
●
Select HP-GL/2 only if you are sending a file of that type directly to the printer, without going through
a printer driver.
ENWW Change the front-panel display contrast 21
Personal settings
To Next Page
Loading...
Need help?
General