CAUTION: Printhead replacement must be performed with the printer powered on.
1.
From the front panel, press
, then , then Replace printheads.
Alternatively, press
, then , then Ink > Replace printheads.
2. The printer moves the carriage into the correct position.
CAUTION: If the carriage is left in the removal position for more than three minutes without
inserting or removing any printheads, it tries to move back to its normal position in the right-hand
end.
3. When the carriage has stopped moving, the front-panel display asks you to open the window.
4. Locate the carriage on the right side of the printer.
5. Pull the handle up and toward you to release the wire loop.
6. Push the handle back to raise the lid.
130 Chapter 13 Handling ink cartridges and printheads ENWW
To Next Page
Loading...