47:03 and 47:10 Starwheel motor error
Call agent:
1. Use the power switch at the rear to turn off the printer, then disconnect the power cord.
Reconnect the power cord, then turn on the printer.
2. Check for any visible obstacles restricting the movement of the starwheel assembly, then clear the
obstruction.
3. Perform the scan-axis starwheel diagnostic test to troubleshoot the problem further.
Service engineer:
1. Check that the starwheel assembly cable is undamaged and correctly corrected to the engine PCA.
2. Replace the starwheel motor. See Starwheel Motor on page 350.
3. Replace the engine PCA. See Engine PCA on page 277.
47.5:10 Problem at the starwheel lifter motor end of the travel sensor
Call agent:
1. Use the power switch at the rear to turn off the printer, then disconnect the power cord.
Reconnect the power cord, then turn on the printer.
2. Check for any visible obstacles restricting the movement of the starwheel assembly, then clear the
obstruction.
3. Perform the scan-axis starwheel diagnostic test to troubleshoot the problem further.
Service engineer:
1. Check that the starwheel lifter sensor cable is undamaged and correctly connected to the engine PCA.
2. Replace the starwheel lifter sensor. See Starwheel Motor on page 350.
3. Replace the engine PCA. See Engine PCA on page 277.
48:00 PRS Actuator system failure
Call agent:
1. Use the power switch at the rear to turn off the printer, then disconnect the power cord.
Reconnect the power cord, then turn on the printer.
2. Perform the scan-axis PRS diagnostic test to troubleshoot the problem further.
Service engineer:
1. Check that the PRS Actuator cable is undamaged and correctly connected to the engine PCA.
2. Replace the printhead-to-paper space solenoid.
3. Replace the engine PCA. See Engine PCA on page 277.
ENWW System error codes in full 129
To Next Page
Loading...
