how do I make original template settings?
djcc-37.htm[28/10/2014 15:47:39]
Map Maps and graphics with a high level of detail
About original template settings
Method
The Method applies to the way the scanner captures and digitizes the
image. The default Method settings for the built-in Type of original
templates are optimal in relation to the kind of original in question
and you shouldn't have to change them. Methods are only applied
with BW copying.
The best method for your selected type of original is named on the
Method button. You can change the method however this is not
normally recommended. To change the method you press the
button and the following options become available:
Graytone: Creates good reproductions of complicated B/W images.
B&W Threshold: For drawings and line art. Uses thresholds to
determine whether a pixel is black or white.
Adaptive: For low contrast and difficult drawings. Clears up and
intensifies low contrast drawings like Sepias, Blueprints, etc.
Lightness
This same setting can also be accessed directly from the Copy tab
dialog. The default Lightness value is set to zero which works well
with most documents. You can change this value to make the copy
lighter (positive value) or darker (negative value) and compensate
for dull or faded originals.
Saturation
Saturation indicates the intensity of a hue, or in other words the
strength of a color. A high saturation makes a color's hue more
intense than the same color with a low saturation value. A positive
value increases saturation and a negative value decreases
saturation.
Red, green, and blue
You can adjust your copy's color balance during image capture
through separate controls for each of the three color-channels Red,
Green, and Blue. Adding and subtracting an amount of a color affects
To Next Page
Loading...
