how do replace scanner parts
djcc-96.htm[28/10/2014 15:48:44]
Lamp effectiveness will gradually weaken over time. Replacement of
the lamp-unit (lamp, reflector, power connectors) is recommended
after long term use. Before replacing the lamp, you should clean the
scan area as described under scanner maintenance to see if any
errors or image defects then disappear.
To replace the lamp unit:
1. Turn the scanner power off and disconnect the power plug.
2. The lamp cover is at the right edge of the scanner. Place a
finger in the gap and gently pull back to free the lid. Pull the
cover sideways and off its hinges to detatch it. The edge of the
lamp unit will now be accessable.
3. You must replace the whole lamp-unit. A lamp-unit consists of
a lamp mounted in a reflector brace and fixed power
connectors.
At the visable edge of the lamp unit there is a handle. Grasp the
handle with your fingers and carefully pull the unit out of the
scanner.
To Next Page
Loading...
