HP Designjet - Using Quick Select Lists

User interface options settings
djcc-46.htm[28/10/2014 15:48:51]
values in Cyan, Magenta, and Yellow (CMY) or Red, Green, and Blue
(RGB) when setting Type of Original options.
paper lists show
Setup tab > Options > General > Paper lists show
This option tells the scanner software whether to display paper sizes
(dimensions) or paper titles (such as E-0, A3) where possible.
use quick select lists
Setup tab > Options > General > Use quick select lists
This option determines the behavior of your interface in relation to
making settings for Type of original, Input size, Output size, Scale,
Printer, Accounting, and Scanner. This option is set by default. The
default dialog order is that you first access an east-to-use list dialog
and from there you can choose a specific Setup dialog by pressing
the tool button
With Quick select lists un-selected, you reverse the above order: your
interface first presents the specific Setup dialog and you must from
there choose to view the List dialog with current predefined and
standard values for the options.
Leave this option selected if you primarily use the scanner software
with standard and customized pre definined option values. Make the
option empty if you primarily need to make specific adjustments and
settings for your different copy jobs and usually bypass the lists with
predefined values.
You can see below the Input size button behavior with and without
the Quick select lists option selected: Quick select lists ON (first) and
OFF (second). The Tool button on the Input Size dialog will activate
the Input Size Setup dialog, and the Input size button in the Input
Size Setup dialog will activate the Input Size dialog.