how do I Collate copies?
djcc-109.htm[28/10/2014 15:46:18]
you are here: welcome how do I...? collate copies
HP Designjet Scanner
how do I...?
the problem is...
alphabetical index
how do I collate copies?
The Collate Copy function allows you to group your copies into sets, and
then output a selected number of these sets on your printer. All the
previewing and enhancement options available for single document
copying are also available when using Collate Copy.
to collate copy - create copy sets
1. Insert the first document of your set into the scanner.
2. Press the Copy tab.
3. Make your copy settings in the Copy tab dialog.
If you wish, you can press the Preview button and make on-
screen adjustments and tests.
4. Press the Collate Copy button.
The original will then be input (captured) as with single-sheet
copying, but it will be put on standby inside your system
instead of going to the printer.
5. Continue inserting originals that belong to the set and press the
Collate Copy button for each one until all the originals that are
part of the set have been scanned.
You can adjust each copy in the set just as you can with single
document copying.
6. Set the number of sets by pressing the button labeled Copies in
the Copy tab.
The number of copies indicates how many sets, each
containing all the input originals, will be output on your printer.
7. Press the Collate Print button to activate the whole copy job.
You can cancel the Collate session at any time by pressing the Reset
button.
To Next Page
Loading...
