how do I use the previewing tools?
djcc-13.htm[28/10/2014 15:47:29]
to zoom out from a selected area...
The Zoom Out tool decreases the image size in the preview
window. If you need to decrease the image further, then
continue to press the Zoom Out button until you get the
required field of view.
one-to-one pixel viewing...
Use the 1:1 tool to view the image with one scanned pixel
shown as one screen pixel. Note that the actual copy/scan
may show additional details as the preview is a low-
resolution view. The preview resolution can be set through
Setup Tab -> Options -> Scanning. Instructions..
to resize the paper frame...
The resize paper frame tool lets you resize the
paper frame interactively in the preview window.
When activated, the Resize Paper Frame Tool
partitions the areas around the paper frame into
sections. When a section is touched, the closest
frame side or corner is resized to the new
position. You can also drag the edges to resize
the frame.
to move the image...
There are two ways to use the move image tool:
Dragging: Dragging anywhere in the image window.
Imagine you are gripping hold of the image and
dragging it around inside the window.
Centering: Touch a point on the screen and that point
will then be centered in the preview window. The
image shifts so that the point you selected
becomes repositioned in the center of the screen.
This method is especially useful when zooming in
on image details. It lets you pick out important
spots and center on them before zooming in.
To Next Page
Loading...
