how do I - output margins?
djcc-107.htm[28/10/2014 15:47:35]
you are here: welcome how do I...? Set Output Margins
HP Designjet Scanner
how do I...?
the problem is...
alphabetical index
how do I set the output margins?
You can set regular "Margins" and additional "Outer margins".
For both types you can define values for top, bottom, left, right.
NOTE: Margins are irrelevant for scan-to-file jobs. All margin values will
automatically be set to zero when working from the Scan tab.
"Margins" are created within the selected scan area and thus replace
edges of the image itself with white border of the breadth defined by
the "Margins" values. ("cropping" the image).
The "Margins" values are deducted from the set Output size and thus
the intended final copy size is retained.
With scaling, the actual margin values are applied to the printed result
while the margin's cropping effect (breadth of cropping edges) on the
scan area is adjusted according to the relation between the input size
and output size (scaling value).
Without scaling (1:1 copying), the actual margin values are applied to
the printed result and are equal to the breadth of the edges that crop
the scan area.
See the examples for clarification.
The "Outer margins" option lets you add additional margins to the scan
area, thus adding white border to the edges of the copy while leaving
the scan area intact. The final copy size is thus extended in relation to
the set output size.
The examples describe actual cases when applying margins and outer
margins.
You can use "Margins" together with "Outer margins" to crop off
unwanted edges. You can also cro off existing low quality (discolored,
unsharp) margins and add new or additional white margins to the end
result.
...how do I set margins?
To Next Page
Loading...
