how do I - auto landscape?
djcc-108.htm[28/10/2014 15:47:37]
you are here: welcome how do I...? Set Output Margins
HP Designjet Scanner
how do I...?
the problem is...
alphabetical index
how do I input in portrait and output in landscape?
The "Auto Landscape" option is useful when you want your copy output
in landscape but inputting the original in landscape with the scanner is
not possible because the scanner is too narrow and you can only insert
the original with portrait (short edge forward) orientation.
Selecting the Setup tab -> Printer-> Advanced -> Auto Landscape option
tells the application to scan the original in portrait orientation and then
automatically rotate the image to landscape in the copy output on the
printer. Use this option when your printer is wider than your scanner and
you want to use the full width of both devices.
NOTE: The process of rotating the image is time and resource
consuming. Therefore, use this option only when you cannot insert the
original in landscape.
...how do I set margins?
1. Select the Setup tab.
2. In the Setup dialog, press the Printer button, the Tool button
and then the Advanced button. The following dialog is
displayed:
3. Select (mark) the box labeled Auto Landscape to activate the
feature
4. When Auto landscape is active it rotates the output 90 degrees.
This happens only when copying originals that are longer than
max scan width, but shorter than the printer's media width
setting. I.e. if you have a printer that prints wider than your
To Next Page
Loading...
