1 Tilt the fence forward
2 Insert the fence into the appropriate slots
3 Tilt the fence back until it locks into place
Note To print on legal-sized paper, set the paper-width guide to LTR.
4. Set the paper-length guide by pulling it until the arrow lines up with the paper size.
1 Align the arrows
Note To print on legal-sized paper, pull the paper-length guide all the way
out.
Load paper
Follow these steps to load paper:
1. Remove the lower tray from the base.
2. Verify that all three paper guides are set to the correct setting.
3. Insert the paper into the lower tray.
User's guide 113
To Next Page
Loading...