4
Connect to the printer
● Wired Ethernet networking
● Connecting a digital camera
● USB
● Bluetooth wireless printing
USB
The printer connects to the computer with a universal serial bus (USB) cable.
For instructions about connecting the printer with a USB cable, see the setup poster that
came with the printer.
Note A USB cable might not be packaged with the printer.
To change a USB connection to an Ethernet connection
If you initially installed the printer as a standalone printer with a USB connection, and
later decided to set up the printer on a network, you must change how the printer is
accessed. If you already understand how to connect to a network, you can use the
general instructions that follow. For more detailed instructions on connecting the printer
to a network, see the setup poster.
1. Unplug the USB connection from the back of the printer.
2. Connect an Ethernet cable from the Ethernet port on the back of the printer to an
available Ethernet port on the router, switch, or access point.
3. Insert the printer software CD in the computer CD-ROM drive.
The Setup Wizard begins.
4. On the Connection Type screen, select Wired Network, and then click Next.
5. Follow the onscreen instructions to complete the network installation.
Wired Ethernet networking
For setup information, click one of the following options:
● Ethernet basics
● What you need for a wired network
● Install the printer on an Ethernet network
18 HP Deskjet 6940 series
To Next Page
Loading...