HP Deskjet 6940 series - Page 64

Prepare to print
1. Verify that the printer is turned on.
2. Remove the Out tray, and then remove all paper from the In tray.
3. Slide the paper-width guide all the way to the left, and then pull out the paper-length
guide.
4. Insert one sheet, pushing it all the way into the printer until it stops.
5. Slide the paper guides firmly against the sheet.
6. Replace the Out tray.
Print
Note Before printing a tattoo, print a practice page to test the layout of the
design. The design might need to be adjusted slightly.
1. If necessary, open the Page Setup dialog box and set the paper size, scaling, or
orientation options.
2. Open the Print dialog box.
3. Select the Paper Type/Quality pane, and then specify the following settings:
– Paper Type: HP CD/DVD Tattoo
Note Selecting this paper type automatically results in a mirrored
image.
– Source: Upper tray
4. Select any other print settings that you want, and then click Print.
Chapter 7
62 HP Deskjet 6940 series