HP Deskjet F4200 Series - Make a copy; Scan an original

3. Close the lid.
Make a copy
You can make quality copies from the control panel.
To make a copy from the control panel
1. Make sure you have paper loaded in the input tray.
2. Load your original print side down on the right front corner of the glass.
3. Press the Paper Selection button to set the paper type.
4. Press Start Copy Black or Start Copy Color.
Scan an original
For original documents or images placed on the glass, you can start a scan from your
computer or from the HP All-in-One. To use the scan features, the HP All-in-One and
computer must be connected and turned on. The HP Photosmart Software must also be
installed and running on your computer prior to scanning.
NOTE: If you are using Windows 2000, use the Windows Scanner wizard instead of
pressing the Scan button.
To scan to a computer
1. Load your original print side down on the right front corner of the glass.
TIP: For quality copies, ensure that the scanner glass is clean and that there are
no foreign materials adhering to it.
2. Press Scan.
3. Make any edits to the preview image, and then click Accept when you are finished.
Chapter 1
6 HP Deskjet F4200 All-in-One series
English