Use PIN method if your WPS enabled router does not have a WPS button
a. Load paper.
❑
Insert stack of paper into paper tray with short edge forward and print side
down.
❑
Slide stack of paper forward until it stops.
❑
Slide paper-width guide to the right until it stops at edge of paper.
b. Print WPS PIN.
❑
Press and hold the Scan button for two seconds.
❑
Wireless test starts.
❑
Wireless test report and Network Configuration report are printed
automatically.
c. Set up wireless connection.
❑
Press and hold the Wireless button for two seconds.
❑
Enter the PIN on a computer for the router.
❑
The Wireless icon and signal strength bar appear solid on successful
configuration of the wireless network.
d. Install software
NOTE: The product begins a timer for approximately two minutes in which the
corresponding button on the networking device needs to be pressed.
Related topics
Install the software for a network connection
Test wireless setup and print network configuration page
The wireless network test performs a series of diagnostic tests to determine whether
network setup is successful. You can print the wireless network test at any time.
You can print a network configuration page to see network settings such as the IP
address, communication mode, and network name (SSID).
To print the network configuration page
▲ Press and hold the Scan button to initiate the wireless test and print the Network
Configuration and Network Test pages.
Chapter 2
6 Finish setting up the HP All-in-One
Finish setting up the HP All-in-One
To Next Page
Loading...