5. Raise the input tray.
6. Lift and hold the input tray shield.
NOTE: Do not remove the input tray shield. The input tray shield prevents foreign debris from falling
into the paper path and causing paper jams.
7. Look down through the open input tray and nd the gray paper pick rollers. You might need a ashlight
to illuminate the area.
8. Dampen a long cotton swab with bottled or distilled water, and then squeeze any excess water from the
cloth.
9. Press the swab against the rollers, and then rotate them upward with your ngers. Apply a moderate
amount of pressure to remove dust or dirt buildup.
10. Lower the input tray shield.
11. Allow the rollers to dry for 10 or 15 minutes.
12. Reconnect the power cord to the rear of the printer.
13. Reconnect the USB cable to the printer if necessary.
14. Press the Power button to turn on the printer.
58 Chapter 7 Solve a problem ENWW
To Next Page
Loading...