Removal and replacement procedures 31
8. Remove all media drives and media drive blanks ("Removing a diskette, DVD, CD-RW drive or
blank" on page 32).
9. Remove the front panel video connector cable.
10. Using the T-15 Torx screwdriver, remove the three screws on each side of the front bezel.
NOTE: The T-15 Torx screwdriver is shipped with the server and can be located on the rear
panel ("Rear panel components" on page 82).
11. While holding down the rack locking levers, slide the bezel to the right, and detach the bezel from
the server.
To replace the component, reverse the removal procedure.
Removing the system cage
Installing or accessing some options in the server might require removing the system cage. See the
instructions for each individual option to determine if removing the system cage is necessary.
To Next Page
Loading...
