Removal and replacement procedures 53
NOTE: If you remove or replace the primary hot-plug power supply, use the T-15 Torx
screwdriver provided with the server to remove the shipping screw. It is located just under the
port-colored plastic handle of the power supply unit.
3. Extend or remove the server from the rack ("Extending the server from the rack" on page 27,
"Remove the server from the rack" on page 29).
4. Remove the access panel ("Removing the access panel" on page 29).
5. Remove the system cage ("Removing the system cage" on page 31).
6. Loosen the thumbscrew, and remove the power backplane from the server.
To replace the component, reverse the removal procedure.
Removing the memory backplane
1. Power down the server (on page 29).
2. Remove all memory boards ("Removing a memory board" on page 67, "Removing a memory board
(non-hot-plug)" on page 65).
3. Remove the processor module ("Removing the processor module" on page 33).
4. Extend or remove the server from the rack ("Extending the server from the rack" on page 27,
"Remove the server from the rack" on page 29).
5. Remove the access panel ("Removing the access panel" on page 29).
To Next Page
Loading...
