Removal and replacement procedures 67
7. Install the memory board.
8. Close the ejector lever, and lock the locking switch.
9. Power up the server.
10. Reference the memory board LEDs ("Memory board components and LEDs" on page 79) to be sure
that the memory board is functioning properly.
Removing a memory board
1. Power down the server if the server is not configured for hot-plug RAID memory or hot-plug mirrored
memory.
CAUTION: Only memory boards with a green Removable LED can be removed. Do not
attempt to remove any memory board with the Removable LED off.
CAUTION: To prevent system failure, do not remove the memory board from the server until
the board status LED stops flashing.
2. Unlock the locking switch, and open the release latch.
To Next Page
Loading...
