HP E8206 ZL

1
Quick Setup Guide for HP E8206 zl Switches
The drawings in this document are for illustration only and may not match your particular switch.
!
For complete installation instructions, see the switch installation guide for this product at:
www.hp.com/networking/support
Rack Mounting Instructions
!
Before installation, read “Installation
Precautions” on page 4.
1. Verify mounting holes. Use bracket template.
A
B
Hole spacing also applies to
pre-drilled racks.
A 0.625 inch (1.588 cm)
B 0.50 inch (1.27 cm)
2. 3.
4. 5.

HP E8206 ZL Specifications

General

Product Type	Switch
Expansion Slots	4
Layer	Layer 3
Input voltage	100-240V AC
Operating humidity	10% to 90% non-condensing
Forwarding rate	95.2 Mpps
Management	Web-based, SNMP, CLI
Height	1.75 inches
Operating temperature	0°C to 45°C