Need help?Do you have a question about the HP 5130 EI Switch Series and is the answer not in the manual?
General| Model | HP 5130 EI Switch Series |
|---|---|
| Jumbo Frames | Up to 9216 bytes |
| Packet Buffer Memory | 4 MB |
| Forwarding Rate | 95.2 Mpps |
| MAC Address Table Size | 32K |
| Routing Protocol | Static, RIP, OSPF, BGP |
| VLANs | 4094 |
| Operating Temperature | 0°C to 45°C |
| Management | Web, CLI, SNMP |
| Operating Humidity | 10% to 90% non-condensing |
| Ports | 24 or 48 10/100/1000 ports, 4 SFP ports |
| Switching Capacity | 128 Gbps |
Essential safety precautions before installing the switch.
Detailed steps for installing the switch in a 19-inch rack.
Procedure for installing and removing power supply modules from the switch.
Steps to connect the switch to an AC power source.
How to connect the switch to DC power or a Redundant Power Supply (RPS).
Setting up a terminal to connect and configure the switch for the first time.
Guide for connecting the console cable between the switch and a terminal.
Required terminal settings and steps to power on the switch.
To Next Page