44
Appendix B FRUs
The H P 513 0 -24G-SFP-4SFP+ EI switch provides two power supply slots. One power supply can meet the
power requirement of the switch. You can install two power supplies on the switch for redundancy. Table
11 describes the power supplies available for the H P 513 0 -24G-SFP-4SFP+ EI switch.
Table 11 Power supplies available for the HP 5130-24G-SFP-4SFP+ EI switch
Power supply model Item Specification Remarks
PSR150-A1
Rated input voltage
100 VAC to 240 VAC @
50 Hz or 60 Hz
For more information
about the power supplies,
see HP PSR150-A &
PSR150-D Power Supplies
User Guide.
Max input voltage
90 VAC to 264 VAC @ 47
Hz to 63 Hz
Max output power 150 W
PSR150-D1
Rated input voltage –48 VDC to –60 VDC
Max input voltage –36 VDC to –72 VDC
Max output power 150 W
When two power supplies are installed, you can hot-swap a power supply. To avoid device damage and
bodily injury, follow the procedures in Fi g u r e 17 and Fi g u re 18 to install and remove the power supply.
To Next Page
Loading...
