Need help?Do you have a question about the HP FlexNetwork 5130 HI series and is the answer not in the manual?
General| Model | HP FlexNetwork 5130 HI series |
|---|---|
| Category | Switch |
| Switch Type | Managed |
| Layer | Layer 3 |
| Power over Ethernet (PoE) | Available on some models |
| Fans | Hot-swappable fans |
| Management | CLI, Web GUI, SNMP, RMON, HP Intelligent Management Center |
| Routing Protocol | RIP, OSPF, BGP, IS-IS, Static Routing |
| Layer 3 Features | VRRP |
| Security Features | ACLs, IEEE 802.1X, RADIUS, TACACS+, SSH, SSL |
| Quality of Service (QoS) | DiffServ |
| Weight | Varies by model |
| Operating Temperature | 0°C to 45°C |
| VLANs | 4094 |
| Operating Humidity | 10% to 95% non-condensing |
Describes basic configuration and display commands for Ethernet interfaces.
Covers Layer 2 specific configurations like storm control and bridging.
Details commands for configuring port VLANs, including hybrid and trunk ports.
Explains how to configure VLANs based on MAC addresses and triggers.
Covers VLAN assignment based on IP subnet or IP address.
To Next Page