HP FlexNetwork 5130 HI series

128
Examples
# Map VLAN 2 to MSTI 1.
<Sysname> system-view
[Sysname] stp region-configuration
[Sysname-mst-region] instance 1 vlan 2
Related commands
• active region-configuration
• check region-configuration
• display stp region-configuration
region-name
Use region-name to configure the MST region name.
Use undo region-name to restore the default MST region name.
Syntax
region-name name
undo region-name
Default
The MST region name of a device is its MAC address.
Views
MST region view
Predefined user roles
network-admin
Parameters
name: Specifies the MST region name, a string of 1 to 32 characters.
Usage guidelines
The MST region name, the VLAN-to-instance mapping table, and the MSTP revision level of a device
determine the device's MST region.
After configuring this command, run the active region-configuration command to activate the
configured MST region name.
Examples
# Set the MST region name of the device to hello.
<Sysname> system-view
[Sysname] stp region-configuration
[Sysname-mst-region] region-name hello
Related commands
• active region-configuration
• check region-configuration
• display stp region-configuration
• instance
• revision-level
• vlan-mapping modulo