HP FlexNetwork 5130 HI series

191
all: Removes all associations between the VLAN and IP subnets or IP addresses.
Usage guidelines
The IP subnet or IP address cannot be a multicast network segment or a multicast address.
Examples
# Configure VLAN 3 as an IP subnet-based VLAN and associate it with the 192.168.1.0/24 network
segment.
<Sysname> system-view
[Sysname] vlan 3
[Sysname-vlan3] ip-subnet-vlan ip 192.168.1.0 255.255.255.0
Related commands
• display protocol-vlan interface
• display protocol-vlan vlan
• port hybrid protocol-vlan
port hybrid ip-subnet-vlan
Use port hybrid ip-subnet-vlan to associate a port with an IP subnet-based VLAN.
Use undo port hybrid ip-subnet-vlan to remove the association.
Syntax
port hybrid ip-subnet-vlan vlan vlan-id
undo port hybrid ip-subnet-vlan { vlan vlan-id | all }
Default
A port is not associated with any IP subnet-based VLANs.
Views
Layer 2 Ethernet interface view, Layer 2 aggregate interface view
Predefined user roles
network-admin
Parameters
vlan vlan-id: Specifies a VLAN by its ID in the range of 1 to 4094.
all: Specifies all VLANs.
Usage guidelines
Only hybrid ports support this feature. Before you use this command, assign the port to the correct IP
subnet-based VLAN.
Examples
# Associate GigabitEthernet 1/0/1 with IP subnet-based VLAN 3.
<Sysname> system-view
[Sysname] vlan 3
[Sysname-vlan3] ip-subnet-vlan ip 192.168.1.0 255.255.255.0
[Sysname-vlan3] quit
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] port link-type hybrid
[Sysname-GigabitEthernet1/0/1] port hybrid vlan 3 untagged