225
voice-vlan enable
Use voice-vlan enable to enable the voice VLAN feature and configure a VLAN as the voice VLAN
for a port.
Use undo voice-vlan enable to disable the voice VLAN feature on a port.
Syntax
voice-vlan vlan-id enable
undo voice-vlan [ vlan-id ] enable
Default
The voice VLAN feature is disabled on ports.
Views
Layer 2 Ethernet interface view
Predefined user roles
network-admin
Parameters
vlan-id: Specifies a voice VLAN ID in the range of 2 to 4094.
Usage guidelines
Use this command only on a hybrid or trunk port operating in automatic voice VLAN assignment
mode.
Examples
# Enable the voice VLAN feature and configure VLAN 2 as the voice VLAN on GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] voice-vlan 2 enable
Related commands
display voice-vlan state
voice-vlan mode auto
voice-vlan mac-address
Use voice-vlan mac-address to configure the OUI address information for voice packet
identification.
Use undo voice-vlan mac-address to delete an OUI address.
Syntax
voice-vlan mac-address mac-address mask oui-mask [ description text ]
undo voice-vlan mac-address oui
Default
System default OUI addresses exist.
Table 50 System default OUI addresses
Number OUI address Vendor
1 0001-E300-0000 Siemens phone
To Next Page
Loading...
Need help?
General