HP FlexNetwork 5130 HI series

235
mrp timer join
Use mrp timer join to set the Join timer.
Use undo mrp timer join to restore the default.
Syntax
mrp timer join timer-value
undo mrp timer join
Default
The Join timer is 20 centiseconds.
Views
Layer 2 Ethernet interface view, Layer 2 aggregate interface view
Predefined user roles
network-admin
Parameters
timer-value: Specifies the Join timer value (in centiseconds). The Join timer must meet the following
requirements:
• Not less than 20.
• Less than half the Leave timer.
• Divisible by 20.
Examples
# Set the Join timer to 40 centiseconds. (In this example, the Leave timer is 100 centiseconds.)
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] mrp timer join 40
Related commands
• display mvrp running-status
• mrp timer leave
mrp timer leave
Use mrp timer leave to set the Leave timer.
Use undo mrp timer leave to restore the default.
Syntax
mrp timer leave timer-value
undo mrp timer leave
Default
The Leave timer is 60 centiseconds.
Views
Layer 2 Ethernet interface view, Layer 2 aggregate interface view
Predefined user roles
network-admin