HP FlexNetwork 5130 HI series

278
Examples
# Configure LLDP to operate in service bridge mode.
<Sysname> system-view
[Sysname] lldp mode service-bridge
Related commands
lldp global enable
lldp notification med-topology-change enable
Use lldp notification med-topology-change enable to enable LLDP-MED trapping.
Use undo lldp notification med-topology-change enable to disable LLDP-MED trapping.
Syntax
lldp notification med-topology-change enable
undo lldp notification med-topology-change enable
Default
LLDP-MED trapping is disabled on ports.
Views
Layer 2 Ethernet interface view, management Ethernet interface view
Predefined user roles
network-admin
Examples
# Enable LLDP-MED trapping for GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] lldp notification med-topology-change enable
lldp notification remote-change enable
Use lldp notification remote-change enable to enable LLDP trapping.
Use undo lldp notification remote-change enable to disable LLDP trapping.
Syntax
In Layer 2 Ethernet interface view or management Ethernet interface view:
lldp [ agent { nearest-customer | nearest-nontpmr } ] notification remote-change enable
undo lldp [ agent { nearest-customer | nearest-nontpmr } ] notification remote-change enable
In Layer 2 aggregate interface view:
lldp agent { nearest-customer | nearest-nontpmr } notification remote-change enable
undo lldp agent { nearest-customer | nearest-nontpmr } notification remote-change enable
Default
LLDP trapping is disabled on ports.
Views
Layer 2 aggregate interface view