4
Field Description
--: Not supported The statistical item is not supported.
Related commands
• flow-interval
• reset counters interface
display counters rate
Use display counters rate to display traffic rate statistics of interfaces in up state over the last
statistics polling interval.
Syntax
display counters rate { inbound | outbound } interface [ interface-type [ interface-number ] ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
inbound: Displays inbound traffic rate statistics.
outbound: Displays outbound traffic rate statistics.
interface-type: Specifies an interface type.
interface-number: Specifies an interface number.
Usage guidelines
The statistics cover only interfaces in up state.
If you specify an interface type, this command displays traffic rate statistics for all up interfaces of the
specified type over the last statistics polling interval.
If you do not specify an interface type, this command displays traffic rate statistics for all up
interfaces that have traffic counters over the last statistics polling interval.
If an interface which is always down over the last statistics polling interval is specified, the system
prompts that the interface does not support the command.
You can use the flow-interval command to set the statistics polling interval.
Examples
# Display the inbound traffic rate statistics for all GigabitEthernet interfaces.
<Sysname> display counters rate inbound interface gigabitethernet
Interface Total (pps) Broadcast (pps) Multicast (pps)
GE1/0/1 200 -- --
GE1/0/2 300 -- --
GE1/0/3 300 -- --
Overflow: More than 14 digits.
--: Not supported.
To Next Page
Loading...
Need help?
General