142
[Sysname-GigabitEthernet1/0/1] stp no-agreement-check
stp pathcost-standard
Use stp pathcost-standard to specify a standard for the device to use when calculating the default
path costs for ports.
Use undo stp pathcost-standard to restore the default.
Syntax
stp pathcost-standard { dot1d-1998 | dot1t | legacy }
undo stp pathcost-standard
Default
The devices uses the legacy standard to calculate the default path costs for ports.
Views
System view
Predefined user roles
network-admin
Parameters
dot1d-1998: Configures the device to calculate the default path cost for ports based on IEEE
802.1d-1998.
dot1t: Configures the device to calculate the default path cost for ports based on IEEE 802.1t.
legacy: Configures the device to calculate the default path cost for ports based on a private
standard.
Usage guidelines
If you change the standard that the device uses in calculating the default path costs, you restore the
path costs to the default.
Examples
# Configure the device to calculate the default path cost for ports based on IEEE 802.1d-1998.
<Sysname> system-view
[Sysname] stp pathcost-standard dot1d-1998
Related commands
• display stp
• stp cost
stp point-to-point
Use stp point-to-point to configure the link type of a port.
Use undo stp point-to-point to restore the default.
Syntax
stp point-to-point { auto | force-false | force-true }
undo stp point-to-point
To Next Page
Loading...
Need help?
General