HP FlexNetwork 5130 HI series - Port Hybrid Protocol-Vlan

194
Table 44 Command output
Field Description
VLAN ID ID of the protocol-based VLAN.
Protocol index Protocol template index.
Protocol type
Protocol type or encapsulation format specified by the protocol
template.
Related commands
• display protocol-vlan interface
• port hybrid protocol-vlan
• protocol-vlan
port hybrid protocol-vlan
Use port hybrid protocol-vlan to associate a hybrid port with the specified protocols in a VLAN.
Use undo port hybrid protocol-vlan to remove the association.
Syntax
port hybrid protocol-vlan vlan vlan-id { protocol-index [ to protocol-end ] | all }
undo hybrid protocol-vlan { vlan vlan-id { protocol-index [ to protocol-end ] | all } | all }
Default
A port is not associated with any protocol-based VLANs.
Views
Layer 2 Ethernet interface view, Layer 2 aggregate interface view,
Predefined user roles
network-admin
Parameters
vlan vlan-id: Specifies a VLAN by its ID in the range of 1 to 4094.
protocol-index: Specifies a beginning protocol template index in the range of 0 to 65535.
to protocol-end: Specifies an end protocol template index of a protocol template range, in the range
of 0 to 65535. The value for the protocol-end argument must be greater than or equal to the
beginning protocol template index.
all: Specifies all protocol templates.
Usage guidelines
Before you use this command, perform the following tasks:
• Create a VLAN and associate it with specified protocols.
• Configure the port link type as hybrid.
• Configure the port to allow the protocol-based VLAN to pass through.
When you execute the undo port hybrid protocol-vlan command on a port, follow these
guidelines:
• If you specify both the vlan-id argument and the all keyword, this command disassociates the
port from all protocol templates of the specified VLAN.