104
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] link-aggregation selected-port minimum 3
Related commands
link-aggregation selected-port maximum
port link-aggregation group
Use port link-aggregation group to assign an Ethernet interface to an aggregation group.
Use undo port link-aggregation group to remove the Ethernet interface from the aggregation
group to which it belongs.
Syntax
port link-aggregation group number
undo port link-aggregation group
Default
An Ethernet interface does not belong to any aggregation group.
Views
Layer 2 Ethernet interface view
Predefined user roles
network-admin
Parameters
number: Specifies an aggregation group by its aggregate interface number in the range of 1 to 1024.
Usage guidelines
An Ethernet interface can belong to only one aggregation group.
Examples
# Assign Layer 2 Ethernet interface GigabitEthernet 1/0/1 to Layer 2 aggregation group 1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] port link-aggregation group 1
reset counters interface
Use reset counters interface to clear statistics for the specified aggregate interfaces.
Syntax
reset counters interface [ bridge-aggregation [ interface-number ] ]
Views
User view
Predefined user roles
network-admin
Parameters
bridge-aggregation: Specifies Layer 2 aggregate interfaces.
To Next Page
Loading...
Need help?
General