97
NOTE:
Packets cannot be load shared based on source MAC addresses when the destination IP addresses
of the packets match multiport ARP entries. For more information about multiport ARP entries, see
Layer 3—IP Services Configuration Guide.
• Destination MAC address.
• Source IP address and destination IP address.
• Source IP address and source port.
• Destination IP address and destination port.
• Source IP address, source port, destination IP address, and destination port.
• Any combination of ingress port, source MAC address, and destination MAC address.
Examples
# Configure the global load sharing mode to load share packets based on destination MAC
addresses.
<Sysname> system-view
[Sysname] link-aggregation global load-sharing mode destination-mac
Related commands
• display link-aggregation load-sharing mode
• link-aggregation global load-sharing algorithm
• link-aggregation global load-sharing seed
• link-aggregation load-sharing mode
link-aggregation global load-sharing seed
Use link-aggregation global load-sharing seed to configure the per-flow load sharing algorithm
seed for Ethernet link aggregation.
Use undo link-aggregation global load-sharing seed to restore the default.
Syntax
link-aggregation global load-sharing seed seed-number
undo link-aggregation global load-sharing seed
Default
Algorithm seed 0 is used.
Views
System view
Predefined user roles
network-admin
Parameters
seed seed-number: Specifies a seed in the range of 1 to 7FFFFFFF.
Usage guidelines
If you execute this command multiple times, the most recent configuration takes effect.
You can configure only the algorithm or the algorithm seed, or both. You can combine an algorithm
with different algorithm seeds to obtain different effects.
To Next Page
Loading...
Need help?
General