163
Example
# Globally enable loop detection for VLAN 10 through VLAN 20.
<Sysname> system-view
[System] loopback-detection global enable vlan 10 to 20
Related commands
• display loopback-detection
• loopback-detection enable
loopback-detection interval-time
Use loopback-detection interval-time to set the loop detection interval.
Use undo loopback-detection interval-time to restore the default.
Syntax
loopback-detection interval-time interval
undo loopback-detection interval-time
Default
The loop detection interval is 30 seconds.
Views
System view
Predefined user roles
network-admin
Parameters
interval: Sets the loop detection interval in the range of 1 to 300 seconds.
Usage guidelines
With loop detection enabled, the device sends loop detection frames at the specified interval. A
shorter interval offers more sensitive detection but consumes more resources. Consider the system
performance and loop detection speed when you set the loop detection interval.
Example
# Set the loop detection interval to 10 seconds.
<Sysname> system-view
[Sysname] loopback-detection interval-time 10
Related commands
display loopback-detection
To Next Page
Loading...
Need help?
General