HP FlexNetwork 5130 HI series

281
undo lldp timer tx-interval
Default
The LLDP frame transmission interval is 30 seconds.
Views
System view
Predefined user roles
network-admin
Parameters
interval: Sets the LLDP frame transmission interval in the range of 5 to 32768 seconds.
Examples
# Set the LLDP frame transmission interval to 20 seconds.
<Sysname> system-view
[Sysname] lldp timer tx-interval 20
lldp tlv-enable
Use lldp tlv-enable to configure the types of advertisable TLVs.
Use undo lldp tlv-enable to disable the advertising of the specified types of TLVs.
Syntax
In Layer 2 Ethernet interface view:
• For nearest bridge agents:
lldp tlv-enable { basic-tlv { all | port-description | system-capability | system-description |
system-name | management-address-tlv [ ip-address ] } | dot1-tlv { all | port-vlan-id |
link-aggregation | protocol-vlan-id [ vlan-id ] | vlan-name [ vlan-id ] | management-vid
[ mvlan-id ] } | dot3-tlv { all | mac-physic | max-frame-size | power } | med-tlv { all | capability
| inventory | network-policy [ vlan-id ] | power-over-ethernet | location-id { civic-address
device-type country-code { ca-type ca-value }&<1-10> | elin-address tel-number } } }
undo lldp tlv-enable { basic-tlv { all | port-description | system-capability |
system-description | system-name | management-address-tlv [ ip-address ] } | dot1-tlv { all
| port-v
lan-id | link-aggregation | protocol-vlan-id | vlan-name | management-vid } |
dot3-tlv { all | mac-physic | max-frame-size | power } | med-tlv { all | capability | inventory |
network-policy | power-over-ethernet | location-id } }
• For nearest non-TPMR bridge agents:
lldp agent nearest-nontpmr tlv-enable { basic-tlv { all | port-description |
system-capability | system-description | system-name | management-address-tlv
[ ip-address ] } | dot1-tlv { all | port-vlan-id | link-aggregation } }
undo lldp agent nearest-nontpmr tlv-enable { basic-tlv { all | port-description |
system-capability | system-description | system-name | management-address-tlv
[ ip-address ] } | dot1-tlv { all | port-vlan-id | link-aggregation } }
• For nearest customer bridge agents:
lldp agent nearest-customer tlv-enable { basic-tlv { all | port-de
scription |
system-capability | system-description | system-name | management-address-tlv
[ ip-address ] } | dot1-tlv { all | port-vlan-id | link-aggregation } }
undo lldp agent nearest-customer tlv-enable { basic-tlv { all | port-description |
system-capability | system-description | system-name | management-address-tlv
[ ip-address ] } | dot1-tlv { all | port-vlan-id | link-aggregation } }
In Layer 2 aggregate interface view: