21
Accessing the switch for the first time
Setting up the configuration environment
The first time you access the switch you must use a console cable to connect a configuration terminal, for
example, a PC, to the console port on the switch, as shown in Figure 26.
Figure 26 Connecting the console port to a terminal
Connecting the console cable
A console cable is an 8-core shielded cable, with a crimped RJ-45 connector at one end for connecting
to the console port of the switch, and a DB-9 female connector at the other end for connecting to the
serial port on the configuration terminal.
Figure 27 Console cable
Table 6 Console cable pinouts
RJ-45 Signal DB-9 Signal
1 RTS 8 CTS
2 DTR 6 DSR
To Next Page
Loading...
