To Next PageTo Next Page
Need help?Do you have a question about the HP A5120-24G EI TAA and is the answer not in the manual?
General| Total Number of Ports | 24 |
|---|---|
| Port Type | Gigabit Ethernet |
| Ports | 24 x 10/100/1000Base-T |
| Uplink Ports | 4 x SFP |
| Management Type | Managed |
| Manageable | Yes |
| TAA Compliance | Yes |
| Form Factor | Rack-mountable |
| Switching Capacity | 48 Gbps |
| Forwarding Rate | 35.7 Mpps |
| Product Type | Switch |
| Layer | Layer 3 |
| MAC Address Table | 16K entries |
| Jumbo Frame Support | 9K bytes |
| Power Supply | AC |
| Dimensions (W x D x H) | 440 x 300 x 44 mm |
| Operating Temperature | 0 °C to 45°C |
| Operating Humidity | 10% to 90% (non-condensing) |
Provides essential safety instructions and warnings for device installation and operation.
Step-by-step guide for rack-mounting A5120 El and SI switch series.
Details on how to properly ground the switch for protection against electrical hazards.
Procedure for connecting AC and RPS DC power cords to the switch.
Guide for installing and removing interface cards on A5120 El switches.
Instructions for connecting a terminal and setting up the console connection.
Steps to power on the switch and verify its operational status.
Covers planning aspects like fabric size, topology, and member IDs.
Procedures for recovering lost console or Boot ROM passwords.
Troubleshooting steps for identifying and resolving power supply issues.
