HP HPE 5140 24G 4SFP+ EI User Manual (English)

Questions and Answers:

D
Donna PowersAug 10, 2025
What to do if there is no display on the HP HPE 5140 24G 4SFP+ EI configuration terminal?
- D
  darlenemorrisAug 10, 2025
  If there's no display on the configuration terminal of your HP Switch, check the following: * Ensure the power system is working correctly. * Confirm the switch itself is operating as expected. * Verify the console cable is properly connected. * Check that the terminal settings are: Baud rate—9600, Data bits—8, Parity—None, Stop bits—1, Flow control—None. * Make sure the console cable isn't faulty.
E
Emily FosterAug 17, 2025
How to fix a garbled display on the HP HPE 5140 24G 4SFP+ EI Switch configuration terminal?
- S
  sandovalmaryAug 17, 2025
  To fix a garbled display on the configuration terminal of your HP Switch, verify that the following settings are configured for the terminal: Baud rate—9600, Data bits—8, Parity—None, Stop bits—1, Flow control—None.
L
Luke Arnold DDSAug 25, 2025
How to troubleshoot a fixed power supply failure due to AC power input failure in an HP HPE 5140 24G 4SFP+ EI?
- S
  Sandra RodriguezAug 25, 2025
  To troubleshoot a fixed power supply failure due to AC power input failure on your HP Switch: * Ensure the AC or DC power cord is correctly connected to the switch. * Verify the AC-input or DC-input power receptacle on the switch and the connected AC or DC power outlet are in good condition. * Confirm the AC or DC power source is operating correctly. * Check that the switch's operating temperature is within the acceptable range and that the power supply has good ventilation. Overheating can cause the power supply to stop working.
F
fvillanuevaSep 2, 2025
Why is the removable power supply failing on my HP HPE 5140 24G 4SFP+ EI Switch?
- M
  Matthew GrahamSep 2, 2025
  If you're experiencing a removable power supply failure with your HP Switch, consider the following: * Check that the AC or DC power cord is correctly connected to the switch. * Confirm that the power supply model is the correct one for the switch. * Ensure the power supply is correctly installed in the switch. * Verify the switch is operating within the acceptable temperature range.

HP HPE 5140 24G 4SFP+ EI Specifications

General

Device Type	Switch
Model	HPE 5140 24G 4SFP+ EI
Ports	24
SFP+ Ports	4
Layer	Layer 2/3
Management	Managed
Switching Capacity	128 Gbps
Jumbo Frame Support	Yes
Input Voltage	100-240 VAC
Weight	3.5 kg
Rack Mountable	Yes
MAC Address Table Size	16K entries
Dimensions (W x D x H)	440 x 260 x 43.6 mm