Need help?Do you have a question about the HP 5500 EI series and is the answer not in the manual?
General| Model | HP 5500 EI series |
|---|---|
| MAC Address Table Size | 32, 000 entries |
| Routing Protocol | OSPF, BGP, RIP, IS-IS |
| VLANs | 4094 |
| Jumbo Frames | 9216 bytes |
| Management | Web, CLI, SNMP |
| Operating Temperature | 0°C to 45°C |
| Operating Humidity | 10% to 90% (noncondensing) |
| Form Factor | Rack-mountable |
| Dimensions (W x D x H) | 440 x 360 x 44 mm |
Manually configure static routes by specifying destination, mask, next hop, and interface.
Enable RIP processes, configure networks, and manage interfaces for RIP operation.
Plan and configure OSPF by enabling it, setting up areas, and managing network types.
Enable OSPF processes globally and on interfaces, and configure router IDs.
Outline tasks for basic IS-IS configuration, route control, and network optimization.
Enable IS-IS processes, assign NET, and configure interfaces for basic operation.
Steps for basic BGP configuration, peer setup, route generation, and path selection.
Configure essential BGP settings, including router ID and enabling BGP processes.
Manually configure IPv6 static routes with destination, prefix, next hop, and interface.
Enable RIPng processes, configure interfaces, and set up basic functions.
Enable OSPFv3 processes globally, assign router IDs, and enable on interfaces.
Enable IPv6 IS-IS processes, configure NET, and enable IPv6 on interfaces.
Create IPv6 policies with nodes, match criteria (ACL, packet length), and actions.
To Next Page
