HP 5500 EI series User Manual

230
Step Command Remarks
4. Apply the IPsec profile to an
IPv6 BGP peer or peer group.
peer { group-name |
ipv6-address } ipsec-profile
profile-name
By default, no IPsec profile is
configured for any IPv6 BGP peer
or peer group.
This command supports only IPsec
profiles in manual mode.
Disabling BGP to establish a session to a peer or peer group
This task enables you to temporarily tear down the BGP session to a specific peer or peer group so that
you can perform network upgrade and maintenance without needing to delete and reconfigure the peer
or peer group. To recover the session, execute the undo peer ignore command.
To disable BGP to establish a session to a peer or peer group (IPv4):
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter BGP view or BGP-VPN
instance view.
• Enter BGP view:
bgp as-number
• Enter BGP-VPN instance view:
a. bgp as-number
b. ip vpn-instance
vpn-instance-name
N/A
3. Disable BGP to establish a
session to a peer or peer
group.
peer { group-name | ip-address }
ignore
By default, BGP can establish a
session to a peer or peer group.
To disable BGP to establish a session to a peer or peer group (IPv6):
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter BGP view or BGP-VPN
instance view.
• Enter BGP view:
bgp as-number
• Enter BGP-VPN instance view:
a. bgp as-number
b. ip vpn-instance
vpn-instance-name
N/A
3. Disable BGP to establish a
session to a peer or peer
group.
peer { group-name |
ipv6-address } ignore
By default, BGP can establish a
session to a peer.
Configuring BGP soft-reset
After you modify the route selection policy (for example, modify the preferred value), you must reset BGP
sessions to apply the new policy. The reset operation tears down and re-establishes BGP sessions.

HP 5500 EI series Specifications

General

Brand	HP
Model	5500 EI series
Category	Switch
Language	English