EasyManuals Logo

HP 5500 EI series User Manual

HP 5500 EI series
424 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #397 background imageLoading...
Page #397 background image
386
Tasks at a
g
lance
(Required.) Configuring IPv6 PBR:
• Configuring IPv6 local PBR
• Configuring IPv6 interface PBR
Configuring an IPv6 policy
Creating an IPv6 node
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Create an IPv6 policy
or policy node, and
enter IPv6 policy
node view.
ipv6 policy-based-route policy-name [ deny |
permit ] node node-number
By default, no IPv6 policy
node is created.
Configuring match criteria for an IPv6 node
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter IPv6 policy
node view.
ipv6 policy-based-route policy-name [ deny | permit ]
node node-number
N/A
3. Configure an ACL
match criterion.
if-match acl { acl6-number | name acl6-name }
By default, no ACL
match criterion is
configured.
4. Configure a packet
length match
criterion.
if-match packet-length min-len max-len
By default, no packet
length match criterion
is configured.
NOTE:
Implementation of the permit or deny action and the time ran
g
e of the specified ACL that an ACL match
criterion uses depends on the device model.
Configuring actions for an IPv6 node
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter IPv6 policy
node view.
ipv6 policy-based-route policy-name [ deny
| permit ] node node-number
N/A
3. Set an IP
precedence.
apply precedence { type | value }
By default, no IP precedence is
specified.

Table of Contents

Other manuals for HP 5500 EI series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP 5500 EI series and is the answer not in the manual?

HP 5500 EI series Specifications

General IconGeneral
BrandHP
Model5500 EI series
CategorySwitch
LanguageEnglish

Related product manuals