209
Ste
Command
Remarks
4. Configure BGP route
dampening.
dampening [ half-life-reachable
half-life-unreachable reuse suppress
ceiling | route-policy
route-policy-name ] *
By default, BGP route dampening
is not configured.
To configure BGP route dampening (IPv6):
Ste
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter BGP view or BGP-VPN
instance view.
• Enter BGP view:
bgp as-number
• Enter BGP-VPN instance view:
a. bgp as-number
b. ip vpn-instance
vpn-instance-name
N/A
3. Enter BGP IPv6 unicast
address family view or
BGP-VPN IPv6 unicast
address family view.
address-family ipv6 [ unicast ] N/A
4. Configure IPv6 BGP route
dampening.
dampening [ half-life-reachable
half-life-unreachable reuse suppress
ceiling | route-policy
route-policy-name ] *
By default, IPv6 BGP route
dampening is not configured.
Controlling BGP path selection
By configuring BGP path attributes, you can control BGP path selection.
Specifying a preferred value for routes received
Perform this task to set a preferred value for specific routes to control BGP path selection.
Among multiple routes that have the same destination/mask and are learned from different peers, the
one with the greatest preferred value is selected as the optimal route.
To specify a preferred value for routes from a peer or peer group (IPv4):
Ste
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter BGP view or BGP-VPN
instance view.
• Enter BGP view:
bgp as-number
• Enter BGP-VPN instance view:
a. bgp as-number
b. ip vpn-instance
vpn-instance-name
N/A