404
Task Command
Display IPv6 prefix list statistics. display ipv6 prefix-list [ prefix-list-name ]
Display MAC list statistics. display mac-list [ mac-list-name ]
Display routing policy information. display route-policy [ route-policy-name ]
Clear IPv4 prefix list statistics. reset ip prefix-list [ prefix-list-name ]
Clear IPv6 prefix list statistics. reset ipv6 prefix-list [ prefix-list-name ]
Clear MAC list statistics. reset mac-list [ mac-list-name ]
Routing policy configuration examples
Applying a routing policy to IPv4 route redistribution
Network requirements
As shown in Figure 97, Router B exchanges routing information with Router A by using OSPF and with
Router C by using IS-IS.
Configure Router B to redistribute IS-IS routes into OSPF, and use a routing policy to set the cost of route
172.17.1.0/24 to 100 and the tag of route 172.17.2.0/24 to 20.
Figure 97 Network diagram
Configuration procedure
1. Configure IP addresses for interfaces. (Details not shown.)
2. Configure IS-IS:
# Configure Router C.
<RouterC> system-view
[RouterC] isis
[RouterC-isis-1] is-level level-2
[RouterC-isis-1] network-entity 10.0000.0000.0001.00
[RouterC-isis-1] quit
[RouterC] interface ethernet 1/1
[RouterC-Ethernet1/1] isis enable
To Next Page
Loading...
Need help?
General