HP 5500 EI series User Manual

198
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter BGP view or BGP-VPN
instance view.
• Enter BGP view:
bgp as-number
• Enter BGP-VPN instance view:
a. bgp as-number
b. ip vpn-instance
vpn-instance-name
N/A
3. Enter BGP IPv4 unicast
address family view or
BGP-VPN IPv4 unicast
address family view.
address-family ipv4 [ unicast ] N/A
4. Inject a local network to the
BGP routing table.
network ip-address [ mask |
mask-length ] [ route-policy
route-policy-name ]
By default, BGP does not advertise
any local network.
To inject a local network (IPv6):
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter BGP view or BGP-VPN
instance view.
• Enter BGP view:
bgp as-number
• Enter BGP-VPN instance view:
a. bgp as-number
b. ip vpn-instance
vpn-instance-name
N/A
3. Enter BGP IPv6 unicast
address family view or
BGP-VPN IPv6 unicast
address family view.
address-family ipv6 [ unicast ] N/A
4. Inject a local network to the
IPv6 BGP routing table.
network ipv6-address prefix-length
[ route-policy route-policy-name ]
By default, BGP does not advertise
any local network.
Redistributing IGP routes
Perform this task to configure route redistribution from an IGP to BGP.
By default, BGP does not redistribute default IGP routes. You can use the default-route imported
command to redistribute default IGP routes into the BGP routing table.
Only active routes can be redistributed. To view route state information, use the display ip routing-table
protocol or display ipv6 routing-table protocol command.
The ORIGIN attribute of BGP routes redistributed from IGPs is INCOMPLETE.
To configure BGP to redistribute IGP routes (IPv4):
Ste
p
Command Remarks
1. Enter system view.
system-view N/A

HP 5500 EI series Specifications

General

Brand	HP
Model	5500 EI series
Category	Switch
Language	English