HP 5500 EI series - Configuring Ripng Route Redistribution

332
# Use IPv6 prefix lists on Router B to filter received and redistributed routes.
[RouterB] ipv6 prefix-list aaa permit 4:: 64
[RouterB] ipv6 prefix-list bbb deny 2:: 64
[RouterB] ipv6 prefix-list bbb permit :: 0 less-equal 128
[RouterB] ripng 1
[RouterB-ripng-1] filter-policy prefix-list aaa export
[RouterB-ripng-1] filter-policy prefix-list bbb import
[RouterB-ripng-1] quit
# Display the RIPng routing tables on Router B and Router A.
[RouterB] display ripng 1 route
Route Flags: A - Aging, S - Suppressed, G - Garbage-collect
O - Optimal, F - Flush to RIB
----------------------------------------------------------------
Peer FE80::1:1 on Ethernet1/1
Destination 1::/64,
via FE80::2:1, cost 1, tag 0, AOF, 6 secs
Peer FE80::3:1 on Ethernet1/2
Destination 3::/64,
via FE80::2:2, cost 1, tag 0, AOF, 11 secs
Destination 4::/64,
via FE80::2:2, cost 1, tag 0, AOF, 11 secs
Destination 5::/64,
via FE80::2:2, cost 1, tag 0, AOF, 11 secs
[RouterA] display ripng 1 route
Route Flags: A - Aging, S - Suppressed, G - Garbage-collect
O - Optimal, F - Flush to RIB
----------------------------------------------------------------
Peer FE80::2:1 on Ethernet1/1
Destination 4::/64,
via FE80::1:1, cost 2, tag 0, AOF, 2 secs
Configuring RIPng route redistribution
Network requirements
As shown in Figure 84, Router B communicates with Router A through RIPng 100 and with Router C
through RIPng 200.
Configure route redistribution on Router B, so the two RIPng processes can redistribute routes from each
other.